Red-Eye Reduction


What is the red-eye effect? The following is an example:

Red-Eye effect

Red-eye is caused by light reflected off the subject's retina, and, as a result, a trace of red appears in the eyes of your subject. If the angle of reflection is less than 2.5 degree, red eye will occur. See the figure below. One way to overcome the red-eye effect is to move closer to your subject so that the angle of reflection is larger than 2.5 degree.

The cause of red-eye effect

Or, you can use the internal red-eye reduction capability, although it may not be very effective.


To activate red-eye reduction in both A-REC and M-REC, use the flash setting button on the back panel:

Press this button until the eye icon appears on both the LCD panel and the LCD monitor as shown below. Once the eye icon appears, all subsequent shots using flash will use red-eye reduction.

Control Panel LCD monitor

When red-eye reduction is in effect, do not move the camera immediately after the shutter release button is pressed to take a photograph. The camera will fire a red-eye reduction light for about one second, and then fire the flash to actually take the photograph you want. Therefore, after pressing the shutter release button, hold the camera steady until the internal flash fires. Note that even with this red-eye reduction capability activated, the red-eye effect may not be gone completely. This situation could even be worse when you take photographs of your pets. See the left and middle images below. The best way is to recompose so that the flash is not pointing directly to your subject's eyes (the right image below). Or, consider the use of an external flash.

With red-eye reduction Use a different angle
Click on the image to see a larger one

Why Does Red-Eye Still Appear Even Though Red-Eye Reduction Is Activated?

The distance between the center of the on-camera lens and the center of the internal flash is approximately 5.5cm. For convenience, let X be the distance from the camera to an eye, and a be the reflection angle (see the figure below). Then, we have X = (5.5/2) / tan(a) = 2.75/tan(a).

To eliminate red-eye, a has to be greater than 2.5 degree. Since tan(2.5 degree) = 0.04, X = 69cm. Since X is inversely proportional to a, to achieve a > 2.5 degree X < 69cm! Therefore, occasionally, red eyes still occur if the camera-subject distance is larger then 69cm.